Greater Toronto Area — Heated Walkways & Driveways
Architectural heated walkways and driveways installed once — then forgotten. Sensors handle the rest.
Every system is sensor-activated, all-inclusive, and installed by a licensed contractor and landscaper team. Choose by scope — we engineer the rest.
Front door approach, steps, and side entry. The highest-risk zone on any property — the narrowest path that ices first and falls hardest.
Full driveway heating from the curb to the garage. No morning scramble. No salt bags in the garage. Just a clear surface — automatically, every time.
Complete estate coverage. Driveway, walkways, patio, and steps on a single zone-controlled sensor system. One install, zero winter effort — property-wide.
Drag to compare a standard property after a GTA snowfall versus the same property with Warmway installed.
Every system includes all seven stages below. No sub-trade finger-pointing. No scope gaps. One crew, fully responsible, start to finish.
We evaluate panel capacity, grading, drainage, and surface type before a single stone is lifted. Your quote is built on facts, not guesswork.
Correct sub-base depth and compaction determines how long the finished surface lasts. We don't cut corners at the foundation stage.
Insulation board beneath the heating element directs warmth upward — not into the ground. Sensor is mounted for accurate moisture and temperature readings.
Cable mats or PEX tubing are laid, and circuit continuity is tested before any covering occurs. We verify before we bury.
Pavers or stone are set to a professional finish. The landscaper on every crew means the surface restoration matches — or improves — the original.
Licensed electrician connects under ESA permit. Sensor thresholds are calibrated. Manual override and run-on timer are configured and tested.
The heating element is covered for 25 years by the manufacturer. The installation — excavation, surface, electrical, sensor — is covered by Warmway's craftsmanship warranty. You're done.
Road salt causes concrete spalling, interlock efflorescence, and joint sand erosion. A heated surface eliminates salt use permanently — preserving a material that cost thousands to install.
Slip-and-fall injuries on residential properties are among the most common winter insurance claims in Ontario. A heated walkway removes the risk — not seasonally, permanently.
The sensor detects moisture and near-freezing temperature simultaneously. The system runs only during actual snowfall, then shuts off automatically. Your involvement: none.
A bone-dry, perfectly maintained approach in February is a listing photo that sells itself. Buyers in Ontario's market recognize a heated surface as a tangible, transferable premium.
A Warmway system is a one-time capital cost that permanently replaces that recurring line item. Most residential installs reach break-even within 7–12 winters — and protect the driveway surface in the meantime.
Electric systems run $12–$25 per sq ft installed and are right for most residential driveways under 1,200 sq ft. Total installed cost typically lands between $8,500 and $22,000. Hydronic systems — best for larger driveways where operating cost at scale justifies the higher upfront — run $35–$44 per sq ft installed. Your exact quote is built from your actual measurements, surface type, and panel distance.
No. The sensor activates only when it detects moisture and near-freezing temperature simultaneously — meaning actual snowfall, not cold dry days or warm rain. Most GTA homeowners see a hydro increase of $30–$80/month during peak winter. For a walkway, it's closer to $5–$20. Compare that to $1,200+ annually for snow removal contracts.
Yes. Paver and interlock surfaces are lifted, mats are set beneath, and pavers are re-set — the finished surface is indistinguishable from before. Concrete and asphalt retrofits use saw-cut channels. The cleanest timing is always alongside a planned resurfacing, but a dedicated retrofit is viable on its own.
The window for full concrete and asphalt installs closes with sustained frost. Paver retrofits can proceed in mild late-autumn weather. If this season is closed, booking now for spring locks in current pricing and puts you at the front of the April queue — the fastest turnaround before next winter. Spring leads are not dead leads.
The heating element itself does not require a building permit. The electrical connection must be performed by a licensed electrician under an ESA (Electrical Safety Authority) permit. Warmway's installs include all ESA-required electrical work — it's in the quoted price, not an add-on.
Tell us about your project. We come to your property, measure accurately, and return an all-inclusive fixed quote — no ranges, no surprises.
Select all that apply to your property.
A rough estimate — we'll measure precisely on-site.
We respond within one business day — by phone or email, your preference.
We'll review your details and reach out within one business day. If your project is this season, we'll flag it and move fast.